Pilz PNOZ m1p base unit Manual do Utilizador descarregar pdf (Página 15)

Installation

Operating Manual PNOZ m1p (ETH)

20878-EN-12

Dimensions







Install base unit without expansion module

} The terminator must be fitted to the side of the base unit marked “Termination/Link”.

} Do not fit a terminator on the left hand side of the base unit.





Connecting the base unit and expansion modules

The modules are linked via jumpers.

There are 2 pin connectors on the rear of the base unit.

A max. of 12 expansion modules plus one fieldbus module may be connected to one base

unit.

} Ensure that no terminator is connected.

} Connect the base unit, the expansion modules and the fieldbus module using the jump-

ers supplied.

} The terminator must be fitted to the last expansion module to the right of the base unit.

} A terminator must not be fitted to the last expansion module to the left of the base unit.

5.2

5.3

5.4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Sem comentários

Pilz PNOZ m1p base unit Manual do Utilizador Página 15