Pilz PSENvip RL D P Manual do Utilizador descarregar pdf (Página 102)

7.4 Enter overrun

7 Commissioning

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

7-20

Fig. 7-19: Enter overrun

 Using the keys , select the overrun that is specified on the type la-

bel of the press brake.

The permitted value range is 2 ... 14 mm, in 2 mm steps.

 Finish the entry using the <ENTER> key.

The PSENvip prompts you to confirm that you accept the new over-

run:

 Within 3 seconds, press the key .

 You can exit the menu at any time without confirming the entry by

pressing <ESC>. In this case, the previous value for the overrun will

be retained.

INFORMATION

The PSENvip will need to be restarted if the entry

- Was invalid

- Took longer than 10 s.

NOTICE

Once the overrun has been entered, you will have to perform a

function test on the safety device (see section entitled "Function

test of the safety device").

SYSTEM OK

OSSD OFF

SETUP

Overrun: 10 mm

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 138 139

Sem comentários

Pilz PSENvip RL D P Manual do Utilizador Página 102