Pilz PSENvip RL D P Manual do Utilizador descarregar pdf (Página 116)

9.1 Error Management

9 Diagnostics and Troubleshooting

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

9-2

9.1Error Management9100Error Management9-Diagnose_F ehlerbehan dlung_Allg

The PSENvip continuously carries out self-tests and output tests during

operation. If an error is discovered, the following sequence is triggered:

 An error identifier is shown on the display of the PSENvip receiver (see

"Error messages" in this chapter)

 The error plus some additional diagnostic data is entered in a special

data area on the PSENvip (see "DIAGNOSTICS menu" in this chapter)

 Execution of the error reaction.

The PSENvip's reaction to an error depends on the severity of that error.

9.1.1 Minor errors

Minor errors9-Diagnose_Fehlerbehandlung_leichte_Fehler

Possible causes

 Feasibility error

 Internal error

Reaction of the PSENvip

 The PSENvip switches to a HOLD state.

 Outputs OSSD1/OSSD2 on the receiver are switched off.

 In this state it is possible to make adjustments during initial commis-

sioning and after a tool change.

Remedy

 Note the error message (see section entitled "Error messages").

 Rectify the error.

 Press the <ESC> key and return the PSENvip to the NORMAL OPER-

ATION state.

9.1.2 Major errors

Major errors9-Diagnose_Fehlerbehandlung_schwere_Fehler

Possible causes

 Serious internal error

 Wiring error, short across contacts, short circuit

 No valid tool data

 Overrun not entered

 Fault on the optical system

Reaction of the PSENvip

 The PSENvip switches to a STOP state.

 Outputs OSSD1/OSSD2 on the receiver are switched off.

 In this state, operation is no longer possible. However, diagnostics

are available.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 138 139

Sem comentários

Pilz PSENvip RL D P Manual do Utilizador Página 116