Pilz PSENvip RL D P Manual do Utilizador descarregar pdf (Página 38)

4.3 Overrun

4 Function description

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

4-10

4.3Overrun4300Overrun4-Funktion_Nachlaufweg_Allgemein

The max. overrun is a press brake variable that will depend on the ma-

chine type. Once the closing movement has stopped, the max. overrun

must not be exceeded.

The overrun is entered during configuration via the keypad on the

PSENvip receiver.

Funktion_Nachlaufweg_P_Variante

Normally, the factory-assigned overrun is sufficient and does not have

to be configured.

Funktion_Nachlaufweg_Warnung_3

INFORMATION

Please refer to chapter 11, "Technical Details", for more informa-

tion about the input area of the overrun.

Details on how to enter the overrun are described in Chapter 7,

“Commissioning”, section entitled “Enter overrun”.

WARNING!

If you require a different overrun path than the factory-set path,

then use the value indicated by the manufacturer on the name-

plate of the press brake, or a higher value.

If you enter a lower value for the overrun, the protected field will

also be reduced to an unpermitted level.

Failure to comply could result in a hazardous situation, which

could lead to serious injury and death.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 138 139

Sem comentários

Pilz PSENvip RL D P Manual do Utilizador Página 38