Pilz PSEN enc s2 eCAM Manual do Utilizador descarregar pdf (Página 66)

Assembly

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Deutschland

Telefon +49 711 3409-0, Telefax +49 711 3409-133, E-Mail: [email protected]

English

4.2 Hollow shaft version

4.2.1 Requirements

As the installation is application-dependent, the following instructions do not

claim to be exhaustive.

 The measuring system should be installed on a greaseless shaft.

 The clamping ring fixing should prevent axial slippage of the measuring

system on the drive shaft, see Figure 3.

 Additional measures may be required to prevent axial slippage of the

measuring system.

 The clamping of the measuring system must not have an axial load.

 The screw on the clamping ring must be tightened to 3 Nm using a

torque wrench.

 The screw on the clamping ring must be secured to stop it coming loose

unintentionally.

 Positive locking using a parallel key/groove combination should prevent

radial slippage of the measuring system on the drive shaft; the

measuring system must be fixed to the drive side using a dowel pin, see

Fig. 4.

Fig. 3: Friction locking

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 92 93

Sem comentários

Pilz PSEN enc s2 eCAM Manual do Utilizador Página 66