Pilz PSENvip RL D P Manual do Utilizador descarregar pdf (Página 59)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

4-31

4.6 Operating modes during commissioning

4 Function Description

4.6.3 Adjustment during tool change

Adjustment during tool change4-Funktion_Betriebsarten_Inbetriebnahme_Justage_Werkzeugwechsel_1

The tool is assigned to a tool class in "Tool change" operating mode.

Once the tool data has been saved it is downloaded to the safety sys-

tem.

Funktion_Betriebsarten_Inbetriebnahme_Justage_Werkzeugwechsel

The adjustment line is automatically tracked to the tip of the tool. The

tracking is shown on the display. This makes it easier to adjust to the dif-

ferent tool sizes.

In this operating mode

 The protected field is inactive.

 The OSSDs are switched off.

 There is no protection via the PSENvip.

4.6.4 Setting the parameters for bending angle measurement

Setting the parameters for bending angle measurement4-Funktion_Betriebsarten_Inbetriebnahme_Biegewinkelmessung

Set and tolerance values for a maximum of 5 angles can be set for bend-

ing angle measurement.

INFORMATION

Generally you should not have to mechanically realign the trans-

mitter and receiver during a tool change.

INFORMATION

Details of the adjustments made during a tool change are

described in Chapter 7, "Commissioning", section entitled

"Adjustment during tool change".

INFORMATION

Details for setting the parameters for bending angle measure-

ment are given in Chapter 7, "Commissioning", under "Setting

the parameters for bending angle measurement".

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 156 157

Sem comentários

Pilz PSENvip RL D P Manual do Utilizador Página 59