Pilz PSENvip RL D P Manual do Utilizador descarregar pdf (Página 78)

6.1 Notes on wiring

6 Wiring

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany

Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]

6-2

Verdrahtung_Hinweise_EMV

EMC

 Avoid interference (e.g. from motors, power lines) by laying cables in

a way that is EMC-compliant.

Verdrahtung_Hinweise_Eingaenge_des_Empfaengers

Inputs on the receiver

 The inputs Protected field mode 1/Protected field mode 2 are safe-

ty-related.

– The CNC or safety system provides the signal. It is only absolutely

necessary to connect the inputs to a safety system if communica-

tion is needed for tool detection.

– When driven via relay contacts it is the user's responsibility to apply

an appropriate safety concept.

The inputs for protected field mode 1 and protected field mode 2 can

be switched directly via the 24 VDC supply. In this case, both inputs

should be linked. Only the following protected field modes are pos-

sible:

– "Standard" protected field mode (switch open, both inputs = "0")

– "Box bending with back gauge" protected field mode (switch

closed, both inputs = "1")

Fig. 6-1: Protected field mode 1/2 directly at the 24 V DC supply

 The input to acknowledge the specified protected field mode can be

switched directly via the 24 VDC supply.

Verdrahtun g_Hinweise_Funk tionspruef ung

NOTICE

The acknowledgement button for the protected field mode must

be positioned outside the danger zone in such a way that the

operator can see all of the danger zone.

Protected field mode 2

Protected field mode 1

24 V DC

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 156 157

Sem comentários

Pilz PSENvip RL D P Manual do Utilizador Página 78